EV Charger Permit Requirements in Town of Edgewood, NM
The Town of Edgewood Planning & Zoning Department issues building (structural) permits within incorporated town limits. New Mexico uses a split permitting system: (1) Building permits are issued locally by the town; (2) Electrical, plumbing, mechanical/HVAC, and LP gas permits are issued at the STATE level by the New Mexico Construction Industries Division (CID), not by the town. CID Santa Fe Regional Office at 2550 Cerrillos Road, 3rd Floor, Santa Fe NM 87505, (505) 476-4700. CID Albuquerque Regional Office at 5500 San Antonio Dr, Suite F, Albuquerque NM 87109, (505) 222-9800. New Mexico adopted the 2021 NMRBC (based on 2021 IRC with state amendments), 14.7.3 NMAC, effective July 14, 2023. Elevation ~6,700 ft, IECC Climate Zone 5B. Contractor licensing through NM CID (GB-2 residential, GB-98 general building, EE-98 electrical, MM-98 HVAC, MS-1/MS-3 plumbing) for work over $7,200/year. Owner-builder permits permitted under 14.5.2.18 NMAC for primary residences (2-year occupancy requirement post-CO). Edgewood also requires a local Business Registration under Ordinance 2023-008 for any business operating in town. IMPORTANT MULTI-COUNTY BOUNDARY: Edgewood straddles Santa Fe, Bernalillo, Sandoval, and Torrance counties via annexation. Town hall and most town area is in Santa Fe County. Parcels outside incorporated town limits fall under the respective county (Santa Fe County Public Works & Permits, Torrance County Planning & Zoning at (505) 544-4393, or the appropriate county). Santa Fe County terrain management rules (slope/drainage analysis, stamped plans) apply to town-area parcels on steep slopes. Wildland-Urban Interface / defensible-space rules apply per Santa Fe County Ordinance 2023-06 adopting 2021 IWUIC; Edgewood is high-desert pinyon-juniper and wildfire-prone. Most properties use private well + septic (no municipal sewer); Liquid Waste Permit from NM Environment Department required (50 ft well-to-tank, 100 ft well-to-drainfield spacing minimum).
By Joey, Founder · Last verified April 24, 2026 · How we research →
When you need a EV Charger permit in Town of Edgewood
Installing a Level 2 EV charger (240V, 30-50 amp dedicated circuit) requires a STATE electrical permit from NM CID, not the town. Level 1 charging on a standard 120V receptacle does not require a permit. A panel upgrade is a separate service-change permit (also state-issued). NM CID EE-98 licensed electrician required.
EV Charger Permit Costs: Town of Edgewood vs. Nearby
| City | Estimated Fee |
|---|---|
| Town of Edgewood | N/A |
| Albuquerque | $75 – $500 |
| Las Cruces | $75 – $500 |
| Rio Rancho | $75 – $500 |
Fees shown are estimates based on local building code data. Actual fees may vary based on project scope and valuation. See all Town of Edgewood permit costs →
Zoning Considerations
EV chargers in private garages or driveways rarely trigger zoning review. Outdoor pedestal chargers may have setback requirements in some jurisdictions. California AB 1236 prohibits requiring a planning permit for residential EV charger installations, building official review only.
Estimated Project Timeline in Town of Edgewood
Here's a typical timeline for a ev charger project in Town of Edgewood, NM:
Timeline is based on Town of Edgewood's typical about 1 week permit processing time. Actual timelines vary by project complexity, completeness of application, and current department workload.
Need an EV Charger permit in Town of Edgewood, NM?
Answer a few quick questions for a personalized answer about your specific project.
Check Now, Free →Building Department Contact
Frequently Asked Questions
Contact Town of Edgewood's building department for current EV Charger permit fee information. Fees typically vary based on project scope and valuation.
It depends on the specifics of your project. Some smaller EV Charger projects may be exempt from permit requirements, while larger ones typically require a permit. Use our free lookup tool to check your specific situation.
Working without a required permit in Town of Edgewood can result in fines, stop-work orders, being required to remove completed work, and complications when selling your home. It's always best to check first.
Typical approval time for EV Charger permits in Town of Edgewood is about 1 week. More complex projects may take longer if plan review is required.
Learn More About EV Charger Permits
Read our complete guide covering permit requirements, costs, common exemptions, and the application process.
Read EV Charger Guide →