How to Get a Kitchen Remodel Permit in Mission, TX (2026 Guide)

Everything you need to know about kitchen remodel permits in Mission, TX, local requirements, fees, timelines, and how to apply.

By Joey, Founder · Last updated May 3, 2026 · How we research →

$150 – $900 Permit Fees
about 2 weeks Approval Time
3 Local Rules

Check your specific kitchen remodel project

Get an instant, personalized answer for your exact project details in Mission.

Free Permit Lookup →

Do You Need a Kitchen Remodel Permit in Mission?

Based on Mission's local building codes, you'll need a permit when:

Required·Rule 1

Kitchen remodels involving plumbing, electrical, or gas changes require permits.

SourceCity of Mission Code / 2021 IRC
Required·Rule 2

Adding a new kitchen requires building, plumbing, electrical, and mechanical permits.

SourceCity of Mission Code / 2021 IRC

These kitchen remodel projects are typically exempt in Mission:

Exempt·Rule 1

Replacing a kitchen appliance in the same location with the same fuel type does not require a permit.

SourceCity of Mission Code / 2021 IRC

Permit Fees in Mission

Based on local Mission permit data, fees for kitchen remodel projects typically range:

$150 – $900 Mission Permit Fee Range

Here's how fees break down by project scope nationally:

Project ScopeTypical Permit Fee
Cosmetic remodel (no plumbing/electrical/structural)Usually exempt
Electrical permit (adding circuits or outlets)$50 – $500
Plumbing permit (moving or adding fixtures)$50 – $500
Building permit (structural changes)$150 – $900
Full gut remodel (all trade permits combined)$500 – $3,000+
Structural engineering (wall removal, if needed)$1,000 – $1,800 (separate from permit)

Fees are typically calculated based on estimated project value. Contact Inspections Division for exact amounts.

How Long Does It Take?

In Mission, typical approval time for kitchen remodel permits is about 2 weeks.

More complex projects requiring structural review or variances may take longer. Simple projects may qualify for expedited or over-the-counter review in some cases.

How to Apply for a Kitchen Remodel Permit in Mission

  1. 1 Check requirements: Use our free lookup tool or contact Inspections Division to confirm your project needs a permit.
  2. 2 Gather documents: Prepare your application, site plan, construction drawings, and any other required documents.
  3. 3 Submit your application: Visit Inspections Division or apply in person at 1201 E. 8th St., Mission, TX 78572.
  4. 4 Pay fees: Pay the applicable permit fees ($150 – $900).
  5. 5 Wait for approval: Your application will be reviewed by Mission plan reviewers. Typical turnaround is about 2 weeks.
  6. 6 Begin work: Once approved, post your permit visibly at the job site before starting work.
  7. 7 Schedule inspections: Call Inspections Division at (956) 580-8672 to schedule required inspections at each phase of the project.

Mission Building Department Contact

NameInspections Division
Address1201 E. 8th St., Mission, TX 78572
HoursMon-Fri 8am-5pm

Required Inspections in Mission

Most kitchen remodel projects in Mission require inspections at each construction stage:

Inspection·Stage 1

Rough Framing Inspection, Correct lumber sizes, spacing, and species/grade per approved plans, headers and beams matching engineering calculations, proper bearing and connections, metal connectors and joist hangers installed with correct fasteners, fireblocking in place, and overall structural integrity.

WhenAfter wall removal, new framing, and structural modifications are complete but before insulation or drywall, inspector must see all structural work
Common FailuresBeam or header undersized for the span, missing or incorrect metal connectors, improper bearing at beam ends, fireblocking not installed.
Inspection·Stage 2

Rough Electrical Inspection, Wire gauge appropriate for circuit amperage, proper box placement and fill calculations, two dedicated 20-amp small-appliance circuits present (NEC 210.11(C)(1)), GFCI and AFCI protection where required, dedicated circuits for dishwasher and disposal, and countertop receptacle spacing compliance.

WhenAfter wiring is run but before walls are closed, often inspected at the same time as framing
Common FailuresMissing dedicated 20-amp kitchen circuits, incorrect wire gauge, GFCI not provided for all kitchen receptacles, countertop outlets spaced too far apart.
Inspection·Stage 3

Rough Plumbing and Gas Inspection, Supply lines properly sized and supported, drain system properly sloped and vented, gas piping pressure-tested (typically 15 PSI air test held for 15+ minutes with no pressure drop), no leaks at any joints, and proper pipe materials and connections.

WhenAfter supply lines, drain/waste/vent piping, and gas lines are installed but before walls are closed
Common FailuresGas piping failing pressure test, drain slope insufficient, vent too far from trap, undersized supply lines for new fixture locations.
Inspection·Stage 4

Final Inspection, All outlets work and GFCI trips properly, all covers on electrical boxes, plumbing has no leaks and drains properly, gas appliances connected and leak-tested, structural connections complete, range hood exhausts to exterior, smoke and CO detectors installed and functional, and overall compliance with approved plans.

WhenAfter all work is complete, cabinets, countertops, appliances, and fixtures installed and connected
Common FailuresGFCI not functioning on all kitchen receptacles, gas leak at appliance connection, range hood not vented to exterior, uncovered electrical boxes.

Schedule inspections with Inspections Division at (956) 580-8672 at least 24–48 hours in advance.

Frequently Asked Questions

Whether you need a permit depends on the size and scope of your kitchen remodel project. In Mission, some smaller projects are exempt while larger ones require a permit. Use our free lookup tool to check your specific situation.

Permit fees for kitchen remodel projects in Mission typically range from $150 – $900. Fees are usually based on the estimated project value.

Typical approval time in Mission is about 2 weeks. Complex projects requiring structural review may take longer.

In most cases, homeowners in Mission can pull permits and perform work on their own primary residence as an owner-builder. You're still responsible for meeting all code requirements and passing inspections.

Working without a required permit in Mission can result in fines, stop-work orders, required removal of completed work, and complications when selling your home.

Ready to check your kitchen remodel project in Mission?

Use our free lookup tool to get a personalized answer based on your specific project details.

Free Permit Lookup →

Kitchen Remodel Permits in Nearby Cities

See kitchen remodel permit requirements in other Texas cities:

See Detailed Kitchen Remodel Rules for Mission

View all local rules, exemptions, and fee details on the permit page.

Kitchen Remodel Permit Rules →
Disclaimer: This guide provides general information about kitchen remodel permit requirements in Mission, TX. Requirements can change. Always confirm with Inspections Division before starting any project. PermitMint provides general guidance, not legal advice.