How to Get a Concrete Slab Permit in Montgomery, AL (2026 Guide)
Everything you need to know about concrete slab permits in Montgomery, AL — local requirements, fees, timelines, and how to apply.
Last updated: April 11, 2026
Check your specific concrete slab project
Get an instant, personalized answer for your exact project details in Montgomery.
Free Permit Lookup →Do You Need a Concrete Slab Permit in Montgomery?
Based on Montgomery's local building codes, you'll need a permit when:
Concrete slabs over 200 square feet typically require a building permit. The permit ensures compliance with IRC R506 (slab design), proper drainage, and impervious surface limits where applicable.
Source: 2015 Alabama Residential Code
Any slab elevated more than 30 inches above adjacent grade requires a building permit. The IRC R105.2 exemption only applies to sidewalks and driveways at or near grade level. Elevated slabs are treated as structural elements and may require footings, guard rails (36 inches minimum per IRC R312.1 for walking surfaces 30+ inches above grade), and engineering review.
Source: 2015 Alabama Residential Code
Any concrete work in the public right-of-way (sidewalks, curb cuts, driveway approaches) ALWAYS requires a permit from Public Works or the Transportation department — not the building department. This applies even if you're replacing an existing damaged sidewalk in front of your own house. The permit ensures ADA compliance, proper slope, and coordination with existing public infrastructure.
Source: 2015 Alabama Residential Code
These concrete slab projects are typically exempt in Montgomery:
Small at-grade patio slabs under 120 square feet are typically exempt from building permits per IRC R105.2 (extended via local amendment). The slab must be at-grade (not more than 30 inches above adjacent grade) and not part of an accessible route.
Source: 2015 Alabama Residential Code
Permit Fees in Montgomery
Based on local Montgomery permit data, fees for concrete slab projects typically range:
Here's how fees break down by project scope nationally:
| Project Scope | Typical Permit Fee |
|---|---|
| Building permit (small patio under 200 sq ft) | $75 – $200 |
| Building permit (larger flatwork) | $150 – $500 |
| Right-of-way / encroachment permit | $100 – $500+ |
| Stormwater permit (for large impervious additions) | $200 – $2,000 |
| Plain broom-finish concrete patio | $6 – $10 per sq ft |
| Stamped concrete (basic pattern) | $12 – $18 per sq ft |
| Stamped concrete (complex/color) | $18 – $30 per sq ft |
| Exposed aggregate | $8 – $14 per sq ft |
| Colored concrete (integral color) | $9 – $14 per sq ft |
| Driveway (4-inch standard) | $5 – $10 per sq ft |
| Sidewalk replacement | $5 – $8 per sq ft |
| Demolition of existing concrete (additional) | $2 – $4 per sq ft |
| Geotechnical soils report (expansive soil areas) | $500 – $2,500 |
Fees are typically calculated based on estimated project value. Contact Inspections Department for exact amounts.
How Long Does It Take?
In Montgomery, typical approval time for concrete slab permits is 5 business days.
More complex projects requiring structural review or variances may take longer. Simple projects may qualify for expedited or over-the-counter review in some cases.
How to Apply for a Concrete Slab Permit in Montgomery
- 1 Check requirements: Use our free lookup tool or contact Inspections Department to confirm your project needs a permit.
- 2 Gather documents: Prepare your application, site plan, construction drawings, and any other required documents.
- 3 Submit your application: Visit Inspections Department or apply in person at 25 Washington Ave., 1st Floor, Montgomery, AL 36104.
- 4 Pay fees: Pay the applicable permit fees ($75 – $600).
- 5 Wait for approval: Your application will be reviewed by Montgomery plan reviewers. Typical turnaround is 5 business days.
- 6 Begin work: Once approved, post your permit visibly at the job site before starting work.
- 7 Schedule inspections: Call Inspections Department at (334) 625-2073 to schedule required inspections at each phase of the project.
Montgomery Building Department Contact
Required Documents for a Concrete Slab Permit in Montgomery
You'll typically need the following when applying for a concrete slab permit in Montgomery:
- Building permit application — For private property flatwork over exemption threshold. Filed by contractor or owner. Includes site plan, dimensions, purpose, estimated cost.
- Site plan — Drawing showing property boundaries, existing structures, slab location, distances to property lines and structures, slab dimensions, grade/drainage pattern. Can be hand-drawn for small projects.
- Encroachment / right-of-way permit application — For any work in public ROW (sidewalks, curb cuts, approaches). Filed with Public Works. Includes traffic control plan for street-adjacent work.
- Geotechnical soils report (expansive soil areas) — Required for larger flatwork in areas with expansive clay soils (CA LA basin, Bay Area, TX DFW). Prepared by a registered geotechnical engineer. Specifies slab design requirements.
- Impervious surface calculation (where applicable) — Shows existing impervious surface on the lot plus the proposed addition, and compares to the city's maximum allowance for your zoning district. Required in Austin, Portland, and other strict jurisdictions before approval.
- Elevation certificate (flood zones) — For slabs in FEMA Special Flood Hazard Areas (SFHA). Shows proposed elevation relative to Base Flood Elevation (BFE). Required for any construction in flood zones.
Requirements may vary. Contact Inspections Department for the complete list of required documents.
Common Mistakes to Avoid in Montgomery
Skipping the permit for ROW work
The most common mistake for sidewalk replacements is thinking 'it's the sidewalk in front of my house, so I don't need a permit.' Wrong — the sidewalk is in the public right-of-way. Any work on it requires a permit from Public Works (not the building department). Unpermitted ROW work can result in fines, required removal, and liability for any injuries on the non-compliant surface.
Ignoring impervious surface limits
Austin, Portland, Seattle, and many coastal cities cap impervious cover on residential lots. Adding a large patio without checking your remaining impervious capacity can trigger a permit denial or an expensive stormwater management plan requirement. Check BEFORE designing.
Not checking for expansive soils
In LA basin, Bay Area, and DFW, expansive clay soils can cause slab heave if not properly designed. Standard 4-inch slabs on expansive clays can crack and lift within a few years. Engineered design (thickened edges, post-tension, or soils engineering letter) may be required. Skip this and you'll be repouring the slab in 3-5 years.
Slab too close to structure foundation
A slab placed tight against the house foundation can trap water against the foundation, causing basement moisture problems. IRC R401.3 requires drainage away from the foundation with minimum 6-inch fall in the first 10 feet. Slabs should slope away from the house at minimum 2% (1/4 inch per foot).
Wrong concrete mix for the climate
In freeze-thaw climates, air-entrained concrete is required for exterior flatwork. Non-air-entrained concrete spalls and cracks within a few winters. IRC R402.2 specifies 3,000-3,500 psi minimum for exterior flatwork in moderate/severe weathering zones. Always specify the correct mix when ordering.
No control joints
Concrete shrinks as it cures and cracks are inevitable. Control joints (scored lines) direct the cracking to predetermined locations where it's hidden. Without control joints every 10 feet maximum, the slab will crack randomly and unattractively. Cut control joints within 24 hours of pour or score during finishing.
Inadequate curing
Concrete must be kept damp for 7 days minimum to reach design strength. Drying too fast (especially in hot, windy weather) causes surface dusting, reduced strength, and premature cracking. Use curing compounds, plastic sheeting, or regular spraying.
Altering neighbor drainage
IRC R401.3 requires that drainage not be altered to direct water onto adjacent property. This is both a code violation and a tort liability issue. Plan the slab grade to maintain existing drainage patterns or include drainage mitigation (swales, French drains, catch basins).
Required Inspections in Montgomery
Most concrete slab projects in Montgomery require inspections at each construction stage:
Pre-pour inspection (for permitted work)
When: After forms are set, reinforcement installed, but before concrete pour
Form dimensions and placement per approved plans, reinforcement type and spacing (if specified), vapor retarder installation (if required), base course thickness and compaction, proper grading for drainage, setbacks from property lines and structures.
Common failures: Forms in wrong location, insufficient base course, missing reinforcement where required, vapor retarder damaged or missing, wrong slab slope for drainage.
Final inspection
When: After concrete is poured and cured
Slab thickness, finish quality, control joints at proper spacing, drainage away from structures, no cracking beyond expected control joint lines, proper curing, compliance with approved plans.
Common failures: Slab too thin, no control joints, poor finish, drainage toward house foundation, uncontrolled cracking from lack of curing.
ROW inspection (for sidewalks, curb cuts, approaches)
When: After completion by Public Works
Compliance with city standard details, proper slope and grade, ADA compliance (where applicable), integration with existing curb and sidewalk, no damage to adjacent public infrastructure.
Common failures: Wrong slope (too steep or not draining), non-standard dimensions, ADA non-compliance, damage to curb or adjacent public concrete.
Schedule inspections with Inspections Department at (334) 625-2073 at least 24–48 hours in advance.
Pro Tips for Concrete Slab Permits in Montgomery
- For small at-grade patios (under 120 sq ft): the permit is often not required, but always call your building department to confirm. Five minutes on the phone saves weeks of back-and-forth later.
- For any ROW work: budget for Public Works approval BEFORE scheduling concrete work. Approvals can take 1-4 weeks and require engineering review.
- Save original receipts and plan documents. Future home buyers' inspectors may ask about slab installations — permit records help establish compliance.
- Before pouring a slab against a foundation, confirm the grading plan with your contractor. Slabs sloping TOWARD the house are a classic problem that leads to basement water intrusion.
- For stamped concrete: the finish quality depends heavily on the installer's experience. Budget extra for contractors with demonstrated stamped concrete portfolios. A bad stamp job is nearly impossible to correct without tearing out the slab.
- Control joints should be at least 1/4 of the slab thickness deep. For a 4-inch slab, joints should be 1 inch deep minimum. Deeper is better — the crack wants to propagate to the deepest weak point.
- Cold weather pouring: concrete needs protection from freezing for 3-7 days minimum. Use insulated blankets or heated enclosures. Pouring below 40°F requires special care.
- Hot weather pouring: concrete cures too fast, causing surface problems. Start early in the morning, use retarders, and cure immediately. Consider fog spraying to slow surface evaporation.
- For pool decks: coordinate with the pool contractor. The deck concrete is typically part of the pool building permit, and design needs to account for bonding, drainage, and chemical exposure.
- For DIY flatwork: start small. A 100 sq ft patio is a manageable weekend project with help. A 500 sq ft driveway is a major undertaking that benefits from professional help.
Frequently Asked Questions
Whether you need a permit depends on the size and scope of your concrete slab project. In Montgomery, some smaller projects are exempt while larger ones require a permit. Use our free lookup tool to check your specific situation.
Permit fees for concrete slab projects in Montgomery typically range from $75 – $600. Fees are usually based on the estimated project value.
Typical approval time in Montgomery is 5 business days. Complex projects requiring structural review may take longer.
In most cases, homeowners in Montgomery can pull permits and perform work on their own primary residence as an owner-builder. You're still responsible for meeting all code requirements and passing inspections.
Working without a required permit in Montgomery can result in fines, stop-work orders, required removal of completed work, and complications when selling your home.
Ready to check your concrete slab project in Montgomery?
Use our free lookup tool to get a personalized answer based on your specific project details.
Free Permit Lookup →Other Permit Guides for Montgomery, AL
Explore more permit guides for Montgomery:
Concrete Slab Permits in Nearby Cities
See concrete slab permit requirements in other Alabama cities:
See Detailed Concrete Slab Rules for Montgomery
View all local rules, exemptions, and fee details on the permit page.
Concrete Slab Permit Rules →