How to Get a Bathroom Remodel Permit in Hardin County, KY (2026 Guide)

Everything you need to know about bathroom remodel permits in Hardin County, KY, local requirements, fees, timelines, and how to apply.

By Joey, Founder · Last updated May 23, 2026 · How we research →

$40 – $825 Permit Fees
about 1 week Approval Time
5 Local Rules

Check your specific bathroom remodel project

Get an instant, personalized answer for your exact project details in Hardin County.

Free Permit Lookup →

Do You Need a Bathroom Remodel Permit in Hardin County?

Based on Hardin County's local building codes, you'll need a permit when:

Required·Rule 1

Bathroom work involving electrical changes such as new outlets or lighting requires an electrical permit. Kentucky requires a licensed master electrician for hired electrical work.

SourceKentucky Building Code / 2018 IRC with local amendments · view source
Required·Rule 2

Bathroom remodels that move plumbing require building and plumbing permits. Kentucky requires a licensed master plumber for hired plumbing work.

SourceKentucky Building Code / 2018 IRC with local amendments · view source
Required·Rule 3

Adding a new bathroom requires building, plumbing, and electrical permits.

SourceKentucky Building Code / 2018 IRC with local amendments · view source
Required·Rule 4

Removing or moving walls in a bathroom requires a building permit to verify structural integrity.

SourceKentucky Building Code / 2018 IRC with local amendments · view source

These bathroom remodel projects are typically exempt in Hardin County:

Exempt·Rule 1

Cosmetic bathroom updates such as paint, fixtures, and vanity replacement without electrical changes do not require a permit.

SourceKentucky Building Code / 2018 IRC with local amendments · view source

Permit Fees in Hardin County

Based on local Hardin County permit data, fees for bathroom remodel projects typically range:

$40 – $825 Hardin County Permit Fee Range

Here's how fees break down by project scope nationally:

Project ScopeTypical Permit Fee
Cosmetic remodel (fixtures stay in place)Usually exempt
Plumbing permit (moving or adding fixtures)$50 – $500
Electrical permit (new circuits or wiring)$40 – $500
Building permit (structural changes)$100 – $500
Full gut remodel (multiple trade permits combined)$400 – $1,500+
Adding a new bathroom$500 – $2,000+

Fees are typically calculated based on estimated project value. Contact Hardin County Planning & Development Commission for exact amounts.

How Long Does It Take?

In Hardin County, typical approval time for bathroom remodel permits is about 1 week.

More complex projects requiring structural review or variances may take longer. Simple projects may qualify for expedited or over-the-counter review in some cases.

How to Apply for a Bathroom Remodel Permit in Hardin County

  1. 1 Check requirements: Use our free lookup tool or contact Hardin County Planning & Development Commission to confirm your project needs a permit.
  2. 2 Gather documents: Prepare your application, site plan, construction drawings, and any other required documents.
  3. 3 Submit your application: Visit Hardin County Planning & Development Commission or apply in person at 150 North Provident Way, Suite 225, Elizabethtown, KY 42701.
  4. 4 Pay fees: Pay the applicable permit fees ($40 – $825).
  5. 5 Wait for approval: Your application will be reviewed by Hardin County plan reviewers. Typical turnaround is about 1 week.
  6. 6 Begin work: Once approved, post your permit visibly at the job site before starting work.
  7. 7 Schedule inspections: Call Hardin County Planning & Development Commission at (270) 769-5479 to schedule required inspections at each phase of the project.

Hardin County Building Department Contact

NameHardin County Planning & Development Commission
Address150 North Provident Way, Suite 225, Elizabethtown, KY 42701
HoursMon-Fri 8:00am-4:30pm

Required Inspections in Hardin County

Most bathroom remodel projects in Hardin County require inspections at each construction stage:

Inspection·Stage 1

Rough-In Plumbing Inspection, Drain pipe routing, sizing, and slope (1/4 inch per foot for pipes under 3 inches), supply line routing and pipe sizes, trap-to-vent distances per IRC Table P3105.1, proper pipe support and hangers, and pipes are typically pressure-tested for leaks.

WhenAfter all drain, waste, vent, and supply pipes are installed but before walls are closed, the inspector must see all piping
Common FailuresIncorrect drain slope, vent too far from trap, undersized pipes, missing cleanouts, drain lines not properly supported.
Inspection·Stage 2

Shower Pan / Waterproofing Inspection, Continuous waterproof membrane properly installed, liner turned up walls at least 2 inches above curb height, drain connection sealed, and a flood test, pan filled with 2 inches of water and held for 15 minutes minimum with no leaking (IRC P2709).

WhenAfter the shower pan liner or waterproof membrane is installed but before tile is applied
Common FailuresLiner not extending high enough on walls, leaking at drain connection, membrane punctures or gaps, failing the flood test.
Inspection·Stage 3

Rough-In Electrical Inspection, Wire gauge appropriate for circuit amperage, circuit routing and box placement, GFCI protection planned for all bathroom receptacles, dedicated 20-amp bathroom circuit, exhaust fan wiring and switch, and wet-location-rated fixtures in shower/tub areas.

WhenAfter wiring is run but before walls are closed, often inspected at the same time as rough-in plumbing
Common FailuresMissing dedicated 20-amp bathroom circuit, GFCI not provided for all receptacles, incorrect wire gauge, no receptacle within 36 inches of basin.
Inspection·Stage 4

Final Inspection, All fixtures installed and functioning, GFCI outlets tested, exhaust fan operational and vented to exterior, plumbing tested with no leaks, proper clearances (21 inches minimum in front of toilet and sink, 24 inches in front of shower entry), minimum 80-inch ceiling height in front of fixtures, and overall compliance with approved plans.

WhenAfter all work is complete, fixtures installed, walls finished, everything operational
Common FailuresExhaust fan not vented to exterior, GFCI outlets not functioning, insufficient clearances around fixtures, plumbing leaks at connections.

Schedule inspections with Hardin County Planning & Development Commission at (270) 769-5479 at least 24–48 hours in advance.

Frequently Asked Questions

Whether you need a permit depends on the size and scope of your bathroom remodel project. In Hardin County, some smaller projects are exempt while larger ones require a permit. Use our free lookup tool to check your specific situation.

Permit fees for bathroom remodel projects in Hardin County typically range from $40 – $825. Fees are usually based on the estimated project value.

Typical approval time in Hardin County is about 1 week. Complex projects requiring structural review may take longer.

In most cases, homeowners in Hardin County can pull permits and perform work on their own primary residence as an owner-builder. You're still responsible for meeting all code requirements and passing inspections.

Working without a required permit in Hardin County can result in fines, stop-work orders, required removal of completed work, and complications when selling your home.

Ready to check your bathroom remodel project in Hardin County?

Use our free lookup tool to get a personalized answer based on your specific project details.

Free Permit Lookup →

Bathroom Remodel Permits in Nearby Cities

See bathroom remodel permit requirements in other Kentucky cities:

See Detailed Bathroom Remodel Rules for Hardin County

View all local rules, exemptions, and fee details on the permit page.

Bathroom Remodel Permit Rules →
Disclaimer: This guide provides general information about bathroom remodel permit requirements in Hardin County, KY. Requirements can change. Always confirm with Hardin County Planning & Development Commission before starting any project. PermitMint provides general guidance, not legal advice.